Networked Media Tank

Bug Description: When I boot the NMT before I switch on the TV, it will show the menus - but will not play any video. When I try to play a video, it will show a black screen for a second, and then fall back to the menu. Its not related to any video codec type or storage place (SMB/HDD).

Ive experienced this issue with an HDMI-attached Philips 32PFL7332 LCD as well as with an Denon AV-Receiver with HDMI inputs at a friends home. So, for me it was pretty much reproducible at two devices.
It does not seem to be fixable with switching the video output of the NMT from "auto" to a manual set mode e.g. "720p60".

Personally, I unplug the power device of the NMT, when I dont use. So, this problem occurs for me every time I plug in the power of the NMT before Ive switched on the LCD and changed to the HDMI-channel.

Firmware: 01-15-080130-14-POP-402

QA results: DId not enocuntered this issue
Remarks: when switch from HDMI 720p 60Hz to Auto mode, encountered the whole page screen is enlarged, happened intermittently

Thanks for the reply. I think the problem might have been connected to a initial configuration that went wrong internally.
When I started up the device few days ago, it was completely reset to factory settings - I still dont know why.
However, the problem did not occur again since then...

So, please close/delete this thread.

Thanks!

ok thx for clear up i move it to fixed